machine manufacturer & steel building constructor

news

Some Small Problems In The Production Of The Roll Forming Machine

Update:07 Dec 2018
Summary:

Roll forming machine often has some minor problems in t […]

Roll forming machine often has some minor problems in the production process. For example, what is the problem of automatic automatic walking? Just touch the travel switch. In fact, it is not a problem with the equipment, but many customers do not understand the principle of the equipment. This requires the most professional commissioning personnel of the manufacturer to help you solve the problem. Each new equipment arrives at the destination and there will be professional commissioning personnel from the factory to help install.

 

The most common problem is the deviation of the roll forming machine. Once the deviation occurs, it will affect the production efficiency of the machine and the product qualification rate. Therefore, we must know how to correct these errors. After a long period of research and exploration, we have come up with How to adjust this problem: If the equipment board runs to the right, you need to use the iron block to the left corner, or the right axis, and the first axis will align the first axis with the other axis. The axis should be consistent with the underlying axis. If the upper row is aligned, the underside should also be aligned. The uniformly symmetrical axis cannot be changed.

 

If it still doesn't work, first adjust the four corners of the front and rear rows of the roll forming machine from the big frame to the height of the upper end of the shaft, and then find a line from the first row to the last row. Straighten, check if the lower shaft is on a horizontal line, and adjust the left and right sides of the lower shaft to level.

 

Find the symmetry point in the first row and the last row of the color steel tile equipment, then fasten the locks on both sides, pull a straight line in front of and behind the center of the middle runner, and adjust the gap between the upper and lower shafts. The machine can be adjusted in a straight line. In fact, the remedy for the deviation of the roll forming machine is that we have long-term production and testing. Different directions of reversal have different remedies, but one thing to note is that both the mechanical axis and other parts need to be aligned on both sides, only two sides. Alignment can maintain symmetry, and the shape of the product will be regular.

 

The roll forming machine can also be referred to as roll cold bend forming, that is, on a row of tandem forming mills, by means of metal sheets and metal strips, which are sequentially bent to process the flat sheet into a plastic shape of the desired cross-sectional shape. Processing method.

Copyright © Yingkou ChangSheng Steel Structure Project Co., Ltd .All rights reserved

Created by:HWAQ