machine manufacturer & steel building constructor

news

K Span Machine (Working Safely and Regularly Maintenance)

Update:26 Oct 2018
Summary:

1. The use of K Span Machine should be carried out in s […]

1. The use of K Span Machine should be carried out in strict accordance with the operating procedures.

2. Each time before starting, press the fixed point, timing, and quantitative lubrication, the oil should be clean and free of precipitation.

3. The ABM 120 roll forming machine this equipment must always be kept clean, the unpainted part needs to add anti-rust grease.

4. The lubricating oil inside the motor bearing should be replaced regularly, and it is necessary to check whether the electrical part is working safely and regularly.

5. Regular inspection and repair insurance, handle, guarantee, switch its work is reliable.

6. Ten minutes before the day of work, lubricate the machine and lubricate it.

7. It is strictly forbidden for non-designated personnel to operate the equipment. It is usually necessary to stop the person from leaving the machine.

First, the filter

1. The filter should be replaced or thoroughly cleaned each time the oil is changed;

2. The air filter on the fuel tank is inspected and cleaned every month and replaced in the following year.

3. If the oil quality of the color steel equipment is not clean, the filter will be abnormal and should be replaced;

Second, hydraulic components

1. Clean hydraulic components (substrate, valve, motor, pump, oil pipe, etc.) every month to prevent dirt from entering the system and not using detergent;

2. After using the new color steel plate equipment for one month, check whether there is any deformation at the bend of each oil pipe. If there is any abnormality, it should be replaced. After two months of use, the joints of all the accessories should be tightened. The system is stress free.

Third, the hydraulic oil circuit

1. Check the oil level of the fuel tank every week. If the hydraulic system is repaired, check it. The oil level should be filled with hydraulic oil below the oil window.

2. The system oil temperature should be between 35 °C and 60 °C, and should not exceed 70 degrees Celsius. If it is too high, it will cause deterioration of oil quality and accessories.

3. The hydraulic oil used in this color steel mechanical machine is ISOHM46 or MOBILDTE25;

Copyright © Yingkou ChangSheng Steel Structure Project Co., Ltd .All rights reserved

Created by:HWAQ